Altazip for WebTV Setup

To setup your WebTV to connect to Altazip go to the Dialing Options Screen. There are two ways to get to this screen:

Method 1: With the WebTV turned on and already connected to the internet, on the Home screen, click onto Setup. Then click Dialing Options.

Method 2: With the WebTV unit turned off, press the Option key three times, then type 2 1 7. The lights on the WebTV unit should flash quickly after this. Then, when the unit is turned on, it should go directly to the Dialing Options screen.

Once you are at the Dialing Options screen, choose Use your ISP.

Read through the next 3 screens and choose Continue on each.

On the next page, choose the option to Use your ISP.

On this screen, check the box at the top. If this box is not checked, you cannot enter the information that you need to use Altazip as your ISP.

• Type ALTAZIP for the Service provider name.
• Enter your Altazip dialup username in the Login name box.
• Enter your Altazip password in the Password box.
• Type 896-2839 into the Modem dial-in number.
  Dashes (-) and spaces are not required.
  If you have a second local access number, type it in the Backup dial-in number box. If not, leave this box blank.

When you have entered the information, click Done.

A message should pop up saying that Your Internet terminal needs to reconnect for your changes to take effect. Click Continue.

If the WebTV unit was already connected, it will hang up and reconnect to a toll-free WebTV to tell WebTV that you will be using an ISP.

The unit will then give you the option to Use your ISP. When you click this option, it will disconnect from the toll-free number and dial the Stargate local access number.

When the WebTV home page is displayed, you have successfully configured your WebTV.